Icom IC-910H - Connections for CW; CW Mode Operation

38
5
RECEIVE AND TRANSMIT
n Connections for CW
Before operating in CW, select the paddle type using
the SSB/CW set mode.
q Push [SSB/CW] to select CW mode.
•“CW”indicatorappears.
w Push [SET] then [SSB/CW] to enter the SSB/CW
set mode.
e Push [DN Z] or [Y UP] to select the paddle type
item.
•“PAddLE”isdisplayed.
r Rotate the tuning dial to select the paddle type.
•Push[M-CL5]for1sec.toreturntothedefaultsetting.
t Push [SSB/CW] to exit the SSB/CW set mode.
n CW mode operation
q Connect a paddle or straight key as above.
wPush[M/S•BAND]toselectthedesiredfrequency
band.
e Push [SSB/CW] to select CW mode.
 •Push[SSB/CW]for1sec.toselectCWnarrowmode
after the CW mode selection when the optional CW nar-
row filter, FL-132 (for MAIN band) or FL-133 (for SUB
band), is installed.
r Rotate the tuning dial to set the operating frequen-
cy.
t Push [TRANSMIT] to set the transceiver to transmit
mode.
 •TheMAINbandindicatorlightsred.
y Operate the paddle or key to transmit the CW sig-
nal.
u Push [TRANSMIT] to return to receive mode.
Tuning dial
[SSB/CW][M/S•BAND][TRANSMIT]
C W
Paddle
Straight key
Microphone
[KEY] jack
[MIC] connector
CW paddle with normal polarity (default)
CW paddle with reverse polarity
CW paddle use as bug-key
Electronic keyer OFF (straight key)
Substitute paddle function
(microphone [UP]/[DN])
NOTE: A stereo plug must be used even when a
straight key is used. See page 12 or 15.
NOTE: [UP]/[DN] keying does not function while
pushing [PTT] on the microphone. Push [TRANS-
MIT] on the front panel or use the semi break-in
function in this case.