Icom IC-910H - Memory Clearing; Call Channels

43
6
MEMORY OPERATION
n Memory clearing
Any unnecessary memory channels can be cleared.
The cleared memory channels become blank chan-
nels.
q Push [V/M 1] to select memory mode.
w Push [DN Z] or [Y UP] to select the desired mem-
ory channel to be cleared.
e Push [M-CL 5] for 1 sec. to clear the contents.
 •Theprogrammedfrequencyandoperatingmodedisap-
pear.
 •“BLANK”indicatorappears.
r To clear other memory channels, repeat steps w
and e.
MEMO
USB
MEMO
BL AN K
Operating band appears
after 2 sec.
MEMO
BL AN K
Beep tone sounds.
n Call channel
The call channel is a one-touch accessible channel for
recalling your most-often-used frequency. The IC-910H
has one call channel for each frequency band.
D Call up a call channel
qPush[M/S•BAND]or[SUB]toselectthedesired
frequency band.
w Push [CALL] to select the call channel.
e Push [CALL] or [V/M 1] to return to previous display.
D Call channel programming
qPush[M/S•BAND]or[SUB]toselectthedesired
frequency band.
w Push [CALL] to select the call channel.
e Enter the desired frequency using the keypad.
e.g.; When programming 145.8200 MHz.
Push [F-INP ENT] ⇒ [1] ⇒ [4] ⇒ [5] ⇒ [.] ⇒ [8] ⇒
[2] ⇒ [F-INP ENT]
 •Selectoperatingmodeifrequired.
r Push [MW 4] for 1 sec. to program the call channel.
D Transferring call channel contents
qPush[M/S•BAND]or[SUB]toselectthedesired
frequency band.
w Push [CALL] to select the call channel.
e Push [M≈V 6] for 1 sec. to transfer the call channel
contents.
F M
USB
VFO A
BL AN K