Icom IC-910H - General Set Mode

n General set mode
56
10
SET MODE
Display backlight brightness
Adjust backlight brightness for the function display to
the desired level within 0 (dark) to 100 (bright) range.
Beep tone
Adjust key touch beep output level to the desired level
within 0 (no output) to 100 (max. output) range.
RF/SQL control assignment
Assign [RF/SQL] control function from rF/SqL, Auto
and SqL.
•rF/SqL :RFgainandsquelchcontrolsarecom-
bined for SSB/CW mode. Acts as
squelch control for FM mode.
•Auto :Acts as either an RF gain or squelch
control depending on operating mode.
•SqL  :Actsassquelchcontrolforallmodes.
RF gain is set to maximum level in this
setting.
Peak hold function
Turn the S-meter peak hold function ON or OFF.
The peak level is indicated for approx. 0.5 sec. when
this function is activated.