Icom IC-910H - 1200 Mhz BAND UNIT

73
11
OPTION INSTALLATIONS
The UX-910 is a band unit for 1200 MHz band opera-
tion. FM, SSB (USB/LSB), CW and CW narrow mode
operations are available.
q Remove the bottom cover as shown in the diagram
on p. 71.
w Remove the antenna plate from the chassis using a
standard screw driver.
WARNING!
NEVER attempt to remove the antenna plate
using your finger, this may result in injury.
e Connect the FFC (Flexible Flat Cable) of the UX-
910 to J2 on the MAIN unit, DC power cable to the
power connector (W305) from the PA unit and the
coaxial cable to the J541 on the PLL unit.
CAUTION
NEVER catch the cables from the optional DSP
unit(s) between chassis and the UX-910, this
may damage the DSP unit(s) and/or transceiver.
J541
J2
UX-910
PLL unit
Power connector
DC power cable
Coaxial cable
Flexible flat cable
r Place the UX-910 using the supplied 4 screws.
BE CAREFUL not to drop the supplied screws
inside the transceiver.
Antenna plate
UX-910
Tu rn the flexible flat cable up under the UX-910.
J2
MAIN unit
Flexible flat cable
UX-910
t Return the bottom cover to its original position.
n UX-910 1200 MHz BAND UNIT