Icom IC-910H - Frequency Setting

22
4
BASIC OPERATION
n Frequency setting
The IC-910H has several tuning steps and a
[kHz/MHz] switch for convenient frequency tuning.
q Push [M/S] to select the desired frequency band as
the MAIN band; or push [SUB] to access the SUB
band.
w Rotate the tuning dial to select the frequency.
 •Thememorychannelnumberchangestothe10and
1 Hz digits when rotating the tuning dial with 1, 10,
100 Hz and 6.25 kHz tuning steps.
 •
When you want to check the 10 and 1 Hz digits during
memory channel number indication, push and hold [A/B]
(10 and 1 Hz digits are indicated while holding).
D Tuning step selection
Tuning steps can be pre-set independently for FM and
SSB/CW. The following steps are selectable.
•FM  :0.1,5,6.25,10,12.5,20,25or100kHz
•SSB/CW :1,10,50or100Hz
q Push [M/S] to select the desired frequency band as
the MAIN band; or push [SUB] to access the SUB
band.
w Push [FM] or [SSB/CW] to select the desired oper-
ation mode.
ePush[kHz/MHz•TS]for1sec.toenterthetuning
step set mode.
r Rotate the tuning dial to select the desired tuning
step.
tPush[kHz/MHz•TS]toreturntopreviousdisplay.
D Quick tuning step
The operating frequency can be changed in 1 kHz
steps or 1 MHz steps for quick tuning.
➥Push[kHz/MHz•TS]toswitchthequicktuningstep
in sequence 1 kHz, 1 MHz and OFF.
USB
VFO A
USB
10 Hz/1 Hz indication
While tuning
[kHz/MHz•TS] for 1 sec.
F M
USB
(20 kHz tuning step)
(10 Hz tuning step)
FM mode tuning step set mode
SSB/CW mode tuning step set mode
[kHz/MHz•TS]
F M
VFO A
1 kHz tuning step1 MHz tuning step