Icom IC-910H - Page 37

35
5
RECEIVE AND TRANSMIT
D Using the one-touch repeater function
(except Europe, Sweden and Italy versions)
By using the pre-programmed offset frequency, shift
direction and tone frequency, quick and simple repeat-
er operation can be made.
The default values for offset frequency and direction
areasfollows:
144MHzband :–0.600MHz
430(440)MHzband:–5.000MHz
1200MHzband :–20.000MHz(optional)
Tonefrequency :88.5Hz
qPush[M/S•BAND]toselectthedesiredfrequency
band.
w Push [FM] to select FM mode.
e Rotate the tuning dial to input the desired repeater
frequency.
 •Directfrequencyinputusingthekeypadcanbeusedfor
frequency setting.
F M
VFO A
r Push [FM] to select the repeater operation mode.
 •“DUP–”and“T”indicatorsappear.
F M DUP
VFO A
T
t Push [PTT] to access the repeater.
F M DUP
VFO A
T
60dB
S
1
3 5
7
9
20
40
Shifts 5 MHz when transmitted.
y Release [PTT] to receive a signal from the repeater.
u Push [FM] to cancel the duplex operation mode.
 •“DUP–”and“T”indicatorsdisappear.
F M
VFO A
D Setting tone frequency
(except Europe, Sweden and Italy versions)
qPush[M/S•BAND]toselectthedesiredfrequency
band.
w Push [SET] then [FM] to enter the FM set mode.
e Push [DN Z] or [Y UP] to select the tone frequency
item.
 •“ton,”selectedband(144/430(440)/1200)and“T”indica-
tor appear.
r Rotate the tuning dial to set the desired tone fre-
quency.
t Push [FM] to exit from the FM set mode.
D Setting offset frequency
qPush[M/S•BAND]or[SUB]toselectthedesired
frequency band.
w Push [SET] then [FM] to enter the FM set mode.
e Push [DN Z] or [Y UP] to select the offset frequen-
cy item.
 •“duP”andselectedband(144/430(440)/1200)appear.
r Rotate the tuning dial to set the desired tone fre-
quency.
t Push [FM] to exit from the FM set mode.
D Manual repeater setting
q Set the desired frequency.
 • Push[M/S•BAND]toselectthedesiredbandifrequired.
 •Push[FM]toselectFMmodeifrequired.
wPush[SPLIT•DUP]for1sec.toselecttheduplex
operation and the shift direction.
 •“DUP–”or“DUP+”indicatorappears,dependingonthe
selection.
 •
Set the offset frequency in the FM set mode, if required.
e Push [TONE] to activate the tone encoder.
 •“T”indicatorappears.
 •SetthetonefrequencyintheFMsetmode,ifrequired
for non-European versions..
 •1750HztoneistransmittedforEurope,Swedenand
Italy versions.
rPush[SPLIT•DUP]for1sec.and[TONE]tocancel
the duplex operation and deactivate the tone en-
coder.
 •“DUP–”or“DUP+”and“T”indicatorsdisappear.