Icom VHF IC-F50

6
2
PANEL DESCRIPTION
2
■ Programmable function keys
The following functions can be assigned to [P0], [P1], [P2], [P3],
[Red], [
] and [ ] programmable function keys.
Consult your Icom dealer or system operator for details concerning
your transceivers programming.
If the programmable function names are bracketed in the follow-
ing explanations, the specific switch used to activate the function
depends on programming.
CH UP AND DOWN KEYS
•Selectanoperatingchannel.
•Selectatransmitcodechannelafterpushingthe[TXCodeCH
Select]keys.
•SelectaDTMFchannelafterpushingthe[DTMFAutodial]key.
•Selectascangroupafterpushingandholdingthe[ScanAStart/
Stop]/[ScanBStart/Stop]keys.
•Select a BIIS code, status number or SDM after pushing the
[Digital]key.
•PushtoselecttheMDCmenuafterpushing[MDCCALL].
•Pushtoselectthedesiredtransceiveraliasormessagechan-
nel while in the transceiver alias or message channel selection
mode.
BANK SELECT KEY
Pushthiskey,thenpush[CHUp]or[CHDown]toselectthede-
sired bank.
SCAN START/STOP KEYS
➥ Push this key to start scanning; and push again to stop.
➥ Push and hold this key to indicate the scan group, then select
thedesiredscangroupusing[CHUp]/[CHDown].
SCAN TAG KEY
Adds or deletes the selected channel to the scan group.