Icom VHF IC-F50

33
4
BIISOPERATION
■ Stun function
When the specified ID, set as a killer ID, is received, the stun func-
tion is activated.
When the killer ID is received, the transceiver switches to the pass-
code required condition. Entering of the passcode via the keypad is
necessary to operate the transceiver again in this case.
■ BIIS indication
ThefollowingindicationsareavailablefortheBIISoperationonan
MSK channel.
: Individual/group call is successful.
 :Message(statusorSDM)transmissionissuccessful.
: No answer back is received.
 :Appearsduringretryofthecall(2ndcall).
: End the communication.
: Operating channel is in the busy condition.
■ Priority A channel selection
When one of the following operations is performed, the transceiver
selects the Priority A channel automatically.
Priority A is selected when;
•Cleardownsignalisreceived/transmitted
- Set the “Move to PrioA CH” item as “Clear Down”.
•TurningthepowerON
The Priority A channel is selected each time the transceiver
power is turned ON.
•Statuscall
The Priority A channel is selected when transmitting a status call.
- Enable the “Send Status on PrioA CH” item in the MSK con-
figuration.