Icom VHF IC-F50

12
3
CONVENTIONAL OPERATION
2
3
■ Turning power ON
qRotate[VOL]toturnpowerON.
w If the transceiver is programmed for a start up passcode, input
digit codes as directed by your dealer.
  •Thekeysinthetablebelowcanbeusedforpasswordinput:
  •Thetransceiverdetectsnumbersinthesameblockasidentical.
Therefore“01234”and“56789”arethesame.
KEY
NUMBER
0
5
4
9
3
8
2
7
1
6
e When the “PASSWORD” indication does not clear after inputting
4digits,theinputcodenumbermaybeincorrect.Turnthepower
off and start over in this case.
■ Channel selection
Several types of channel selections are available. Methods may dif-
fer according to your system set up.
NON-BANK TYPE:
Push [
]/[ ]toselectthedesiredoperatingchannel,inse-
quence;or,pushoneofthe[MR-CH1]to[MR-CH4]keystoselect
a channel directly.
BANK-TYPE:
Push[Bank],thenpush[ ]or[ ]toselectthedesiredbank.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning the
power ON, the transceiver automatically starts scanning. Scanning
stops when receiving a call.