Icom VHF IC-F50

25
4
BIISOPERATION
D Direct code entry
qWhileinthestandbycondition,push[TXCodeEnter]toenter
the TX code edit mode.
 •Editablecodedigitblinks.
wPush[TXCodeEnter]toselectthedesireddigittobeedited.
 •Editabledigitdiffersaccordingtothesetting.
e Set the desired digit using [ ]/[ ]/[TXCodeCH Up]/
[TXCodeCHDown].
rPush[TXCodeEnter]tosetthedigit.Theeditabledigitwillmove
to the right automatically.
t Repeat e and r to input all allowable digits.
yPush[P0](Call)or[PTT]*tocall.
 *PTTcallcanbemadeonlywhenPTTcallcapabilityispermitted.
NOTE: When no answer back is received, the transceiver re-
peatsthecall3times(default)automatically,and
“ ” is
displayed during each call. However, an error beep sounds
and
“ ” is displayed when no answer back is received
after the calls.
uPush[PTT]totransmit;releasetoreceive.
iPush[P3](Moni(Audi))tosendthe“Cleardown”signal.
For your information
When the “UpDate” setting for the call code is enabled, the set code
is overwritten into the call code memory.