Icom VHF IC-F50

39
5
MDC1200OPERATION
D Transmitting a Message
The transceiver can send a pre-programmed message to the dis-
patcher.Thereare16messagesthatcanbesentonachannel.
qPush[MDCCall]toentertheMDCmenuselectionmode.
wSelect“MSG”using[CHUp],[CHDown],[MDCUp]or[MDC
Down].
ePush[MDCCall]againtoenterthepre-programmedmessage
selection mode.
Pre-programmed message is displayed.
rSelectthedesiredmessageusing[CHUp],[CHDown],[MDC
Up]or[MDCDown].
tPush[PTT]totransmitthemessagetothedispatcher.
 •“MSGTX”isdisplayed.
yRelease[PTT].
 •“MSGOK”isdisplayed.
 •“MSGFAIL”isdisplayedifthereisnoacknowledgmentfromthe
dispatcher.
u After a specified time period has passed, the transceiver will re-
turn to receive.