34 PRT-KLCD Protege Alphanumeric LCD Keypad User Manual | April 2011
(4) Show User Memory On Logon
The user will be shown the alarm memory when they logon. It is recommended to also enable option three when
option four is enabled.
(5) Disarm Primary Area On Logon
When enabled the user only needs to enter their user code and press the [ENTER] key. If the primary area for the
keypad is armed it will be disarmed.
(6) Disarm User Area On Logon
Operating the same as option five however the area assigned in the users area location will be disarmed if it is
armed. Use this option to control lighting and HVAC for an office area.
(7) User Can Acknowledge Trouble Message
When enabled this option will give the user permission to acknowledge trouble conditions in the system when the
require trouble acknowledgement is enabled.
(8) User Can Acknowledge SYSTEM Trouble Message
This option operates the same as option seven however allows a user to acknowledge system trouble
conditions.
UN00010 Special
[********]
The display will show the users special options programming screen. An option can be toggled on and off by
using the numerical keys [1] to [8]. To view the options in text entry mode press the [STAY] key.
(1) Users Area Configured As Area Group
This option will allow a users area to be programmed as a group providing the ability to control multiple user
areas.
(2) Reserved Option
A reserved option, do not change this option.
(3) User Is A Super User
Setting the super user option gives the user a privileged status allowing them to override anti-passback and other
settings that will prevent normal access.
To Next Page
Loading...
