36 PRT-KLCD Protege Alphanumeric LCD Keypad User Manual | April 2011
Once the user name is displayed use the up [] and down [] keys to scroll to the next user. Modifications can
be made and WILL be saved if the [] or [] keys are pressed.
UN00011 Name
G Bates
In the example shown pressing the up [] key moves to the next user (UN00011) and shows the name.
Removing User Codes
To remove a user code from the system but monitor if the user code or card has been attempted to be used
refer to Disabling User Codes (see page 37). Follow the procedures below to remove a user number and
associated i
nformation or to re-assign the user number to another user.
Select user to
modify: UN00010
Select the user. Once the desired user is displayed press the [ENTER] key.
UN00010 Name
J Smith
Once the user name is displayed clear the name entry by pressing the [DISARM] key. Press the [ENTER] key to
move to the User Code entry screen.
UN00010 User
code: 1234
To clear the user code press the [DISARM] key. Press the [ENTER] key to save the changes and move to the
next programming screen. This will prevent pin number access using the user code.
UN00010 Acs LvlÎ
Administration
Clear the access level setting to none by pressing the [DISARM] key. Press the [ENTER] key to save the
changes and move to the next programming screen. Press the [ENTER] repeatedly until you are at the facility
code programming entry.
UN00010 Facility
id: 0000000279
The display will show the users card facility programming screen. Clear the facility code by pressing [DISARM]
key and then press enter to save the changes and move to the next screen.
UN00010 Card
no: 0030497182
The display will show the users card number programming screen. Clear the card number by pressing [DISARM]
key and then press enter to save the changes.
Repeat the above steps as required for other users.
To Next Page
Loading...
