42
SBS Only: Please enable it when you issue cards with software programed by SDK. This
option disables printer device driver.
Safe Head Heat: Set not to print if the print head is overheated.
Cleaning Warning: Set to show the ‘Do cleaning’ message periodically
Use USB Serial: When SOLID-310 is connected to USB, it transmits the USB serial
number to PC. Default is the same number used by all SOLID-310. Please set this option
when you use multiple SOLID-310 printers connected to 1 PC via USB. It enables unique
serial numbers for each USB.
Mag. Head Position: SOLID-310 can install the magnetic encoder on upper/lower side of a
card. You can set it depending on the position of encoder.
Card Out: Set the way to eject cards.
Error Card Out: Set the way to eject error cards.
Auto Front Card In: Set to input a card automatically if the front card-in sensor detects a
card. It is used for the KIOSK model.
Auto Rear Card In: Set to input a card automatically if the rear card-in sensor detects a
card. It is used for the KIOSK model.
Dump Mode: It records log data to inspect the operation of printer.
User Mag. Current: The default current value when the user selects to use the defined
value when magnetic encoding
Mag. Write Mode: You can order the way how to encode magnetic stripe.
“L:A, H:I”: encodes 3 tracks at once for LoCo card and encodes at twice by dividing 1,3 and
2 track for HiCo card.
Magnetic Start Position: Set the start position of magnetic stripe when you encode.
Card In Speed: set the speed of inputting a card
Card Move Speed: set the speed of moving a card
Card Eject Speed: set the speed of ejecting a card
To Next Page
Loading...
