idp SOLID Series - Figure 63 Running the Netadmin; Figure 64 Network Printer Is Not Found

45
(2) Network configuration
NetAdmin is run as the Pic.72 after
turning on SOLID-310 network
printer.
① Printer Connection Status
Searches local network, finds and
shows available network printer.
② Network Module Management
Searches connected encoder on
network module. Reboots, Resets
network module. Firmware upgrade
available
③ Printer Configuration
Sets detailed system configuration.
④ Network Information
Shows firmware version of network
module
Figure 63 Running the NetAdmin
When no printer is connected to
network, there is no printer shown
on the box.
Please click “Refresh”.
If no printer shown, please check as
below,
1. Please check the printer is turned on.
2. Please check network cable is
connected to network hub and works
properly (LED lamp blinking).
3. Please check if there is DHCP server
in the local network. When DHCP
server is not in your local network,
you need to set Static IP.
4. If Static IP is used, please check the
IP configuration. If another device
uses same IP address, it doesn't
work.
Figure 64 Network printer is not found
③
④
②
①