prox.pad Installation/Programming Manual
1.8 Items Supplied from the Factory
The following items are supplied from the factory with the initial prox.pad shipment.
● prox.pad unit
● Request to Exit (REX) button (also called the “Filler Piece”)
● Request to Exit Label and Blank Label
● Antenna Housing and Backplate for mounting
● 2 Pin jumper (installed on connector)
● Lithium battery (installed in unit)
● Silicone Rubber “dogbone” for Request to Exit switch
● Self-Adhering Pads
● Hex Wrench
● Wire Harnesses
● Installation Hardware
● Quick Start Installer Guide
● CD with Installation/Programming Manuals
1.9 Items the Installer Must Supply
For each prox.pad unit installation, the installer must supply the following items:
● Proximity Cards or Keyfobs; The prox.pad unit works with these four types of cards:
• Prox Card II
• IsoProx II
• Duo Prox II
• Proxkey FOB
● an appropriately rated linear DC Power Supply (12-15 VDC) (filtered and regulated recommended)
● the appropriate installation electrical tools
● Remote Antenna Cable [ALPHA 1294C (22AWG) 4-wire, stranded and shielded] (this is required ONLY if you choose to
remote the antenna 10 feet away from the keypad/controller)
● Wiegand Interface Cable [ALPHA 1295C] (22AWG) 5-conductor, stranded and shielded] (this is required ONLY if using a
separate Wiegand control panel)
● Power Supply Cable (18AWG-22AWG) 2-wire stranded (depends on distance)
● Door Lock Cable (18AWG-22AWG) 2-wire stranded (depends on distance)
● Door Monitor Cable (18AWG-22AWG) 2-wire stranded (depends on distance)
● REX Cable (if using remote switch) [ALPHA 2421C 18 AWG or ALPHA 1292C 22 AWG, 2-conductor, stranded and
shielded]
● Tamper Switch; Either Ademco 945T or PR-20451 magnet and reed switch or equivalent
Page 10 of 86 Document # 6055676, Rev 2.2, D4b
To Next Page
