prox.pad Installation/Programming Manual
Table of Contents
Chapter 1: Introduction/Installation.................................................................................8
1.1 About this Manual..........................................................................................................................8
1.2 Safety Warnings and Cautions......................................................................................................8
1.3 Design Change Disclaimer............................................................................................................8
1.4 Reproduction Disclaimer...............................................................................................................8
1.5 FCC Statement..............................................................................................................................8
1.6 Technical Support.........................................................................................................................9
1.7 Warranty .......................................................................................................................................9
1.8 Items Supplied from the Factory.................................................................................................10
1.9 Items the Installer Must Supply...................................................................................................10
1.10 General Description...................................................................................................................11
1.11 Operating Modes.......................................................................................................................11
1.12 prox.pad Specifications.............................................................................................................12
1.13 Installation Configurations.........................................................................................................13
1.14 Other Installation Considerations..............................................................................................14
1.14.1 Power Supply/Current Requirements................................................................................14
1.14.2 Gang Box and Mounting....................................................................................................14
1.14.3 Mounting the Unit on Metal................................................................................................14
1.14.4 RF Interference .................................................................................................................14
1.15 Checking the Cables.................................................................................................................15
1.16 Mounting the prox.pad Unit.......................................................................................................19
1.16.1 Performing a Wall Mounted Installation.............................................................................19
1.16.2 Performing a Glass Mounted Installation...........................................................................20
1.16.3 Performing a Secure Installation........................................................................................21
1.16.4 Installing a Tamper Switch.................................................................................................23
1.16.4.a Mounting over a metal or plastic single gang J-Box...................................................23
1.16.4.b Wall mounting.............................................................................................................23
1.17 Removing/Inserting Circuit Boards............................................................................................24
1.18 Defaulting prox.pad Memory.....................................................................................................25
Chapter 2: Standalone Mode........................................................................................26
2.1 Standalone Mode Description.....................................................................................................26
2.1.1 Standalone Features............................................................................................................26
2.2 Inputs/Outputs ............................................................................................................................26
2.3 Unit Capacity...............................................................................................................................27
2.4 Alarm Output Selection...............................................................................................................27
2.5 Wiring the prox.pad Unit..............................................................................................................28
2.5.1 Wiring the AUX Relay for Use as Alarm Shunt....................................................................28
2.5.2 Wiring the AUX Relay for Use as Forced Door...................................................................29
2.5.3 Wiring the AUX Relay for Use as Propped Door.................................................................30
2.5.4 Wiring the Door Contact Input..............................................................................................31
2.5.5 Wiring an External REX Switch (Request to Exit)...............................................................32
2.5.6 Wiring the Main Relay..........................................................................................................33
2.6 Testing the prox.pad....................................................................................................................34
2.6.1 Testing the Controller/Keypad.............................................................................................34
2.7 Programming in Standalone Mode..............................................................................................35
Page 2 of 86 Document # 6055676, Rev 2.2, D4b
To Next Page
Loading...
