prox.pad Installation/Programming Manual
2.7.5.e Enabling/Disabling Daylight Savings Time
Daylight savings time can be enabled or disabled using option 13. It is enabled by default. To enable/disable the feature use the
following command sequence:
1. Enter Program Mode.
Press: 99 # Master Code *
The yellow LED flashes slowly.
2. To enable this feature, press: 30 # 13 # 1 # **
The yellow LED continues to blink slowly.
To disable this feature, press: 30 # 13 # 0 # **
The yellow LED continues to blink slowly.
3. Exit Program Mode.
Press: *
The yellow LED stops flashing.
2.7.5.f Selecting Daylight Savings Time Format
You can program the prox.pad Daylight Savings Time Format to either European format or US format. The formats are as follows:
● United States Format:
○ Begins Second Sunday in March - turn ahead 1 hour @ 2:00 AM
○ Ends First Sunday in November - turn back 1 hour @ 2:00 AM
● European Format:
○ Begins Last Sunday in March - turn ahead 1 hour @ 2:00 AM
○ Ends Last Sunday in October - turn back 1 hour @ 2:00 AM
The command sequence is as follows:
1. Enter Program Mode.
Press: 99 # Master Code *
The yellow LED flashes slowly.
2. To select European DST Format, press: 30 # 8 # 1 # **
The yellow LED continues to blink slowly.
To select US DST Format, press: 30 # 8 # 0 # **
The yellow LED continues to blink slowly.
3. Exit Program Mode.
Press: *
The yellow LED stops flashing.
Page 48 of 86 Document # 6055676, Rev 2.2, D4b
To Next Page
Loading...
Need help?
General
