prox.pad Installation/Programming Manual
2.8.2 Dumping a Transaction Event Log
You can dump a transaction event log to the optional Data Collection Device (DCD) PDA Software via the prox.pad’s IR LED, using
two different methods. You can either program a Log Dump User (user type 2) into memory or place the prox.pad into program mode
and manually enter the Log Dump command (command 70). Refer to the instructions with the Data Collection Device for details on
that product.
2.8.2.a Programming a Log Dump Code or Card
Below is an example of programming a “code only” or a “card only” Log Dump User. You can also use any of the other user
programming commands to program this user type. Refer to the user programming section for details.
1. Enter Program Mode
Press: 99 # master code *
The yellow LED flashes slowly.
2. Program the “Code Only” Log Dump User.
Press: 50 # 2 # user location # code * repeat code *
Program the “Card Only” Log Dump User.
Press: 50 # 2 # user location # ** <present card>
The yellow LED continues to blink slowly.
3. Exit Program Mode
Press: *
The yellow LED stops flashing.
Now to dump the log to the Data Collection Device, simply enter the code or present the card while outside programming mode. Prior
to entering the code/presenting the card, make sure you've set the Data Collection Device to capture the data and place the device in
front of the IR LED. After you enter the log dump code/present card, the unit beeps 3 times and then the green LED flashes and
yellow LED blinks slowly. When complete, the red LED turns on solid and the yellow LED continues to blink slowly.
2.8.2.b Dumping a Transaction Log Manually
You also have to option to dump the transaction log by entering command 70 while in program mode. To perform this function follow
the command sequence below.
Note: Prior to entering command 70, make sure you've set the Data Collection Device to capture the data and place the device in front
of the IR LED.
1. Enter Program Mode.
Press: 99 # Master Code *
The yellow LED flashes slowly.
2. Enter the command to erase memory.
Press: 70 # 0 # 0 # **
The unit beeps 3 times and then the green LED flashes and yellow LED blinks slowly. When complete, the red LED turns
on solid and the yellow LED continues to flash slowly.
3. Exit Program Mode.
Press: *
The yellow LED stops flashing.
Page 54 of 86 Document # 6055676, Rev 2.2, D4b
To Next Page
Loading...
Need help?
General
