prox.pad Installation/Programming Manual
2.8.2.c Erasing the Transaction Log Memory
The Transaction Log should be erased from memory after being printed to prevent conflicting logs. To erase the log, enter the
following sequence:
1. Enter Program Mode.
Press: 99 # Master Code *
The yellow LED flashes slowly.
2. Enter the command to erase log memory.
Press: 76 # 00000 # 00000 # **
The yellow LED continues to blink slowly.
3. Exit Program Mode.
Press: *
2.8.2.d Dumping a Programmed User List
You can dump the programmed users list, containing all user information, to the optional Data Collection Device via the prox.pad's IR
LED using command 25. You can either dump the entire user list or dump the user list starting at a specific user location.
When you dump the user list to the Data Collection Device all users from the starting location to user 2000 are transmitted, including
empty user locations. You'll be able to see exactly where each user code is stored in memory. This is important in case you ever need
to delete or modify a particular user.
1. Enter Program Mode.
Press: 99 # Master Code *
The yellow LED flashes slowly.
2. Enter the command to dump the entire user list.
Press: 25 # 0 # 0 # **
Enter the command to dump the user list starting at a specific location.
Press: 25 # 0 # start user location # **
The unit beeps 3 times and then the green LED flashes and yellow LED blinks slowly. When complete, the red LED turns
on solid and the yellow LED continues to flash slowly.
3. Exit Program Mode.
Press: *
The yellow LED stops flashing.
Document # 6055676, Rev 2.2, D4b Page 55 of 86
To Next Page
Loading...
Need help?
General
