prox.pad Installation/Programming Manual
4.3 Secured Series Front End LED Indicators/Sounder Operations
Table 11: prox.pad LED Indicators/Sounder Operations – Secured Series Mode
LED/Sounder Visual/Audible Condition Description
Yellow LED
Slow blink Unit is in Program mode
Rapid blink
Verify mode is active (checking that the last two values in
sequence match)
Steady Program error; entry error lockout (no keypress feedback)
Very rapid blink Memory (eeprom) erase is in progress (command 46)
“Pulsing” rapid blink
Batch program of cards in progress (command 56); block
delete of users (command 58)
Bi-color LED
Steady red Lock is locked
Steady green Lock is energized (timed or latched)
Quick double red/green flash Prox card read correctly
All LED's
Rapid red, yellow, green
sequencing
Power on/reset
Sounder
(system)
Very quick beep (10 ms) with
yellow LED blink every second
EEPROM read error during get system parameters; can
be turned off by running self-test
Sounder (after
PIN)
3 rapid beeps after PIN not found
Sounder (after
card)
3 very rapid beeps
PIN not found, facility code/company ID mismatch and
access by facility mode enabled; incorrect card type
(option #20)
1 short beep Valid card access
4.4 Secured Series Front End Mode Default Settings
Option Default Setting Option Default Setting
Master Code 1234 Audio Keypress Feedback Enabled
Visual Keypress Feedback Enabled Auto-Entry Disabled
Anti-Passback Enabled Reader In/Out Select In
Keypad In/Out Select In Prox Card Type 26-bit
Facility Match Required Disabled Facility Code 1
Corporate 1000 ID 4095
Document # 6055676, Rev 2.2, D4b Page 71 of 86
To Next Page
Loading...
Need help?
General
