IEI Technology WAFER-JL-N5105 User Manual

WAFER-JL-N5105 SBC
Page 48
WARNING:
The installation instructions described in this manual should be carefully
followed in order to prevent damage to the WAFER-JL-N5105, WAFER-JL-
N5105 components and injury to the user.
Before and during the installation please DO the following:
 Read the user manual:
o The user manual provides a complete description of the WAFER-JL-
N5105 installation instructions and configuration options.
 Wear an electrostatic discharge cuff (ESD):
o Electronic components are easily damaged by ESD. Wearing an ESD
cuff removes ESD from the body and helps prevent ESD damage.
 Place the WAFER-JL-N5105 on an antistatic pad:
o When installing or configuring the motherboard, place it on an antistatic
pad. This helps to prevent potential ESD damage.
 Turn all power to the WAFER-JL-N5105 off:
o When working with the WAFER-JL-N5105, make sure that it is
disconnected from all power supplies and that no electricity is being fed
into the system.
Before and during the installation of the WAFER-JL-N5105 DO NOT:
 Remove any of the stickers on the PCB board. These stickers are required
for warranty validation.
 Use the product before verifying all the cables and power connectors are
properly connected.
 Allow screws to come in contact with the PCB circuit, connector pins, or its
components.

IEI Technology WAFER-JL-N5105 Specifications

General

Brand	IEI Technology
Model	WAFER-JL-N5105
Category	Single board computers
Language	English