IEI Technology WAFER-JL-N5105 User Manual

WAFER-JL-N5105 SBC
Page 67
D.1 PEI Beep Codes
Number of Beeps
Description
1
Memory not Installed
1
Memory was installed twice
(InstallPeiMemory routine in PEI Core called twice)
2
Recovery started
3
DXEIPL was not found
3
DXE Core Firmware Volume was not found
4
Recovery failed
4
S3 Resume failed
7
Reset PPI is not available
D.2 DXE Beep Codes
Number of Beeps
Description
1
Invalid password
4
Some of the Architectural Protocols are not available
5
No Console Output Devices are found
5
No Console Input Devices are found
6
Flash update is failed
7
Reset protocol is not available
8
Platform PCI resource requirements cannot be met
NOTE:
If you have any question, please contact IEI for further assistance.

IEI Technology WAFER-JL-N5105 Specifications

General

Brand	IEI Technology
Model	WAFER-JL-N5105
Category	Single board computers
Language	English