BIOS Setup Information
WEB-6580
【
R1.0
】
User’s Manual 4-19
Set this option to Enabled to specify that the IDE controller on the PCI local
bus has bus mastering capability.
DMA Channel 0/1/3/5/6/7
These options specify if the named DMA channel is available for using on
the ISA/EISA bus or PnP (Plug & Play).
IRQ 3/4/5/7/9/10/11/12/14/15
These options specify the bus that the named interrupt request lines (IRQs)
are used on. These options allow you to specify IRQs for use by legacy ISA
adapter cards. These options determine if AMIBIOS should remove an IRQ
from the pool of available IRQs passed to devices that are configurable by
the system BIOS. The available IRQ pool is determined by reading the
ESCD NVRAM. If more IRQs must be removed from the pool, the end user
can use these PCI/PnP Setup to remove the IRQ by assigning the option to
the ISA/EISA setting. All IRQs used by on-board I/O are configured as
PCI/PnP.
4.9 Peripheral Setup
This section describes I/O resources assignment for all of on-board
peripheral devices.
On Board FDC
To Next Page
Loading...
Need help?
General
