IFM Electronic AL1122 - LR DEVICE: Configure the Device

32
ifm Operating Instructions IO-Link Master with EtherNet/IP interface StandardLine 8 Ports IP 65 / IP 67 (AL1122) 2017-05-31
Configuration
>
8.2 LR DEVICE: Configure the device
Configure the Ethernet interface ............................................................................................................33
Configure communication profile ............................................................................................................34
Configure the interface to the SmartObserver........................................................................................35
Set the operating mode of the IO-Link ports ..........................................................................................36
Set device validation and data storage ..................................................................................................37
Reset IO-Link master to factory settings ................................................................................................39
7948
On delivery, the AL1122 is configured with the → Factory Settings (→ p. 60) configured.
Further information about operation and functions of the LR DEVICE parameter setting
software:
► Use the help function of the parameter setting software LR DEVICE!
Requirements
> The device is properly connected with the LR DEVICE laptop/PC via the EtherNet/IP interface.
> LR DEVICE is correctly installed (→ Software manual LR DEVICE).
1 Start LR DEVICE.
► Start LR DEVICE.
> Web browser shows LR DEVICE user interface.
2 Scan network
► Scan network for new IO-Link masters.
> Under [ONLINE], the article number and the IP address of the device appear.
3 Set network parameters
► Under [ONLINE]: Click on the AL1122.
> LR DEVICE shows the following sections:
Section
Functions
[Alle]
all available functions
[Network]
→ Configure the Ethernet interface (→ p. 33)
[LineRecorder]
→ Configure communication profile (→ p. 34)
→ Configure the interface to the SmartObserver (→ p. 35)
[Port x]*
→ Set the operating mode of the IO-Link ports (→ p. 36)
→ Set device validation and data storage (→ p. 37)
[Setup]
→ LR DEVICE: Read device information (→ p. 55)
→ Reset IO-Link master to factory settings (→ p. 39)
→ Reboot the device (→ p. 56)
* ... x = 1...8