iiNet TG-1 - 2 Setup

SETUP
DMS3-CTC-25-115 v1.0
11
2
2 Setup
Introduction
Proceed as follows:
1 Connect the TG-1 Gateway to your service provider’s network.
For more information, see “2.1 Connecting the TG-1 Gateway to your service provider’s network” on
page 12.
2 Power on the TG-1 Gateway.
For more information, see “2.2 Powering on the TG-1 Gateway” on page 14.
3 Connect your network devices. To do this using:
 A wireless connection, see “2.3 Connecting your wired devices” on page 15.
 A wired connection, see “3 Wireless networking” on page 18.
4 Connect your phones, see “2.4 Setting up your telephone network” on page 16.
5 After completing the setup procedure, the TG-1 Gateway is ready for use. Optionally, you can further
configure the TG-1 Gateway to your needs (for example, change the wireless security) using the TG-1
Gateway GUI.
For more information, see “4 The TG-1 Gateway GUI” on page 28.
We recommended you to first connect one computer/tablet (if possible via a wired connection),
then secure your wireless connection first and as a final step connect the other devices.
For more information, see “Secure your wireless connection!” on page 18.