THE TG-1 GATEWAY GUI
DMS3-CTC-25-115 v1.0
37
4
4.4.4 Wireless
The Wireless card
The Wireless card displays:
The status of the wireless interface
The network names (SSIDs) used by the wireless access points
Wireless ON/OFF switch
In the Wireless card header, you can see whether the wireless interface is enabled or not. If the switch is
set to:
then the wireless interface is enabled. Clicking the switch will disable all access points on the TG-
1 Gateway.
then the wireless interface is disabled. Clicking the switch will enable all access points on the TG-
1 Gateway.
The Wireless page
Click the Wireless card header to open the Wireless page.
On the left of the Wireless page you can select the access point that you want to configure:
The first access point is the main access point and allows you to connect you home network devices.
The second access point is the guest access point and allows you to provide wireless Internet access
to guests. For more information see “3.5 Using the guest access point” on page 27.
For each of these access points, you can:
View or change the wireless interface settings.
View or change the access point settings
Start a WPS push button configuration
Generate a QR code to connect a wireless device.
Configuration examples
In this User Manual you can find information on how to:
Change the wireless security settings.
For more information, see “3.4 Changing the wireless security settings” on page 24.
Configure and use WPS.
For more information, see “3.1 Connecting your wireless client via WPS” on page 19.
Use the QR code.
For more information, see “3.3 Connecting your wireless client by scanning a QR code” on page 22.
The guest access point is disabled by default
To Next Page
Loading...
