26
WIRELESS NETWORKING
DMS3-CTC-25-115 v1.0
3
3.4.2 Configuring WPA encryption
Procedure
Proceed as follows:
1 Browse to the The TG-1 Gateway GUI.
For more information, see “4.1 Access from your local network” on page 29.
2 Click Wireless. The Wireless page appears.
3 In the Security Mode list under Access Point, select one of the following modes:
WPA+WPA2
WPA2
For more information, see “Encryption types” on page 24.
4 The following RADIUS settings are now available for configuration:
Radius Authentication Server's IP: enter the IP address of your RADIUS server.
Radius Authentication Server's port: enter the WPA Radius Port.
Radius Authentication Server's secret: enter the WPA Radius Key.
5 Click Save to immediately apply your changes.
6 Reconnect your wireless client(s) to the TG-1 Gateway using these new security settings.
For more information, see “3.1 Connecting your wireless client via WPS” on page 19 or “3.2 How to
manually connect a wireless client” on page 21.
To Next Page
Loading...
