vi
BS-98 1409 VER1 (U) (E)
SAFETY PRECAUTIONS
Regarding the Modules
Pay attention to the following points when handling the modules:
- Do not let the parts of the modules or the printed wiring pattern to touch the metal parts that can
be energized.
- Avoid placing or storing the modules in humid places.
- Do not touch the parts of the modules or the printed wiring pattern with dirty or wet hands. Do
not touch them with hands unless necessary.
Regarding the Power and the Lithium Battery
Use the product in compliance with the rating of the fuse. Otherwise, a fault can occur.
Do not use an unspecified battery.
Wrong usage of batteries may cause liquid leak, explosion, and heat, and at worst injury or fire.
When changing or discarding a battery, please contact Ikegami's sales and service centers.
■
Maintenance
Regarding the product
Before performing maintenance on the product, be sure to turn off the power for safety and for
protection against malfunction.
Clean the product using a dry and soft cloth.
If the product is very dirty, wipe with a cloth moistened with water or neutral detergent and wrung
out. If neutral detergent is used, wipe again with a cloth dipped in clear water and wrung out.
■
Regular Maintenance Recommended
This product includes parts that wear out and have a limited life even in proper use or storage. Therefore, regular maintenance (once
every 3 years or 8000 hours use) is recommended to extend the life and safe use of this product for a long time. Please contact
Ikegami's sales and service centers or Techno Ikegami Co., Ltd. for the regular maintenance and repair of our products.
To Next Page