56
BS-98 1409 VER1 (U) (E)
5.1 Settings from the BS Menu
■
Displaying the Submenu
You can perform various settings on the submenu that is displayed from the main menu on the PM screen.
1 Make sure that the main menu is displayed on the PM
screen.
2 Turn the MASTER PEDESTAL control knob or IRIS
control knob on the MCP to position the flashing cursor
on the setting item, and press the CALL button.
The submenu appears, on which you can perform various
settings.
CAUTION:
Depending on the functions of the setting items, some items change the setting when the knob is turned; others change the setting
when the CALL button is pressed.
Note:
- To return to the main menu, select " " and press the CALL button.
- The flashing item on the submenu indicates the currently focused item. This flashing status is called the "flashing cursor" hereafter
(displayed in gray in the display example).
- Each time the CALL button is pressed, the flashing cursor switches to setting item -> mode selection -> setting item -> mode
selection and so on.
■
Exiting the Menu
This section explains how to exit the main menu/submenu on the PM screen.
1 Exit the menu screen in the any of the following methods :
a) Select "
" on the BS/CCU main menu and press the CALL button.
b) Press the BARS button (to OFF COLOR BARS).
The main menu/submenu disappears.
ＦＩＬＥ ＳＥＬＥＣＴ ＥＮＧＩＮＥＥＲ−１
ＬＯＡＤ ＳＴＡＲＴ ＳＴＡＲＴ
ＰＲＥＳＥＴ ＦＩＬＥ ＬＯＡＤ
ModesettingSettingitems
To Next Page
Loading...