72
BS-98 1409 VER1 (U) (E)
5.1 Settings from the BS Menu
OUTPUT FORMAT setting item list
Setting items Setting Content
OUT-1 Changes depending on the
FORMAT.
Selects OUT-1 output from the sub menu.
OUT-2 Changes depending on the
FORMAT.
Selects OUT-2 output from the sub menu.
OUT-3 Changes depending on the
FORMAT.
Selects OUT-3 output from the sub menu.
When SDTV option is implemented, SD-SDI also becomes selectable.
PM-1 PM HD-SDI PM-1 OUT output is set to HD-SDI. The output format is selected by "HD PM"
item.
PM SD-SDI PM-1 OUT output is set to SD-SDI. Only when SDTV option is implemented,
selection is enabled.
PM-2/WFM WFM (OUT-3) The signal that is the same as the one selected at OUT-3 is output.
PM HD-SDI PM-2 OUT output is set to HD-SDI. The output format is the same as PM-1.
PM SD-SDI PM-2 OUT output is set to SD-SDI. Only when SDTV option is implemented,
selection is enabled.
HD PM Changes depending on the
FORMAT.
The output format for when PM HD-SDI is selected to PM-1 and PM-2 OUT is
selected.
SD SCREEN MODE 4:3 The aspect ratio of SDTV output is set to 4:3.
16:9 The aspect ratio of SDTV output is set to 16:9.
LETTER SDTV output is set to the letter box mode.
SYNC OUT Changes depending on the
FORMAT.
For the HDTV system, Tri-Level synchronizing signal, of which output is possible
with the SYSTEM FORMAT currently selected, can be selected.
SDTV is the 2Vp-p SDTV rate synchronizing signal (not BBS).
HD-SYNC 2-3ID ADD
(Can be set only when
1080P23PD)
ON Set as the pulse signals that counted the first to fifth frames superimpose in the
SYNC output.
OFF Above signals are not superimposed.
--- Is not selectable.
SD-10 FIELD ID SIG
(Can be set only when
1080P23PD)
ON Set as the pulse signals (Level 40IRE) that counted the first to fifth frames to 15H
and 278H superimpose in the ENC output.
OFF Above signals are not superimposed.
--- Is not selectable.
To Next Page
Loading...