Image Access WideTEK 25 - Picture 12: Self Test 1; Picture 13: Self Test 2; A.12.6 Self Test Mode

Manual Page 27
A.12.6 Self Test Mode
While the start sequence is running, the WideTEK 25 can be switched to Self Test mode.
Tapping on the touch panel at least three times starts the setup mode. After the start
sequence is finished, the touch panel shows the Self Test 1 screen.
Picture 12: Self Test 1
To move forward to the
Self Test 2
screen touch the button
.
Picture 13: Self Test 2
To return to the former screen touch
.