Image Access WideTEK 36 - How to Recover to Factory Defaults; Picture 73: Position of Gap on Right Side; Picture 74: Position of Gap on Left Side; Picture 75: Moving the Compensator Plate Upwards

C.6.2 How to Recover to Factory Defaults
1. Power the device down with the stop button.
2. Remove the metal compensator. This is down within a few steps easily.
At first open the upper unit by clicking the locking lashes at the left and right side of the
housing.
Then find a gap at the right side of the
compensators plate
Picture 73: Position of gap on right side
Picture 74: Position of gap on left side
and a gap at the left side of the
compensators plate where you can pull the
compensator plate upwards.
Picture 75: Moving the compensator plate
upwards
Pull the compensator plate slowly backwards
to the document table
Page 62 Setup and Assembly Manual