Image Access WideTEK 36 Setup And Assembly Manual

Error codes, part 2
Error
#
Error message shown in
the display
Error message sent to
application
Problem description
30 File format not supported. The specified file format is not supported
or it is invalid in combination with the
color mode.
31 Preview not possible.
The application specified an invalid
preview scale. Not all scale factors are
allowed with all image sizes.
32
The application specified an
invalid preview scale. Not all
scale factors are allowed with
all image sizes.
The application changed the color depth
between scanning and image transfer
and a conversion between these modes
is not possible. Example: scan in binary,
then changed color mode to truecolor.
33
No image available
The application attempted to get an
image from the scanner and there was
no scan since the device was turned on.
55 Error 55: Wrong S2N Board
(CCD Ports)
Wrong S2N board detected
(not enough CCD ports)
The S2N board found is not the right one
for this device. Error can occur after a
repair/exchange. Exchange with correct
board.
56 Error 56: S2N Board: wrong
revision
Wrong S2N Board detected
(Revision not OK)
The S2N board found is not the right one
for this device. Error can occur after a
repair/exchange. Exchange with correct
board.
60 Error 60: General camera
error
General camera error.
General error on the CCD camera board.
Check power, cables and S2N-PCI
board.
61 Error 61: Loading camera 1
failed
Load camera 1 failed.
Initializing of camera 1 failed. Check
power, cables and S2N-PCI board.
62 Error 62: Loading camera 2
failed
Load camera 2 failed.
Initializing of camera 2 failed. Check
power, cables and S2N-PCI board.
63 Error 63: Loading camera 3
failed
Load camera 3 failed.
Initializing of camera 3 failed. Check
power, cables and S2N-PCI board.
65 Error 65: Camera 1 data bus
error
Camera 1 data bus error.
Test data transfer to camera failed.
Check cables / connectors to camera 1
and S2N-PCI board.
66 Error 66: Camera 2 data bus
error
Camera 2 data bus error. Test data transfer to camera failed.
Check cables / connectors to camera 2
and S2N-PCI board.
67 Error 67: Camera 3 data bus
error
Camera 3 data bus error.
Test data transfer to camera failed.
Check cables / connectors to camera 3
and S2N-PCI board.
69 Error 69: ADC error camera 1 Camera 1 adc error. Test data transfer through analog digital
converter failed. Check cables /
connectors to camera 1.
Page 66 Setup and Assembly Manual

Image Access WideTEK 36 Specifications

General

Brand	Image Access
Model	WideTEK 36
Category	Scanner
Language	English