Immergas VICTRIX TERA V2 35 PLUS EU - Page 109

109
INSTALLER
USERMAINTENANCE TECHNICIAN
TECHNICAL DATA
Victrix Tera V2 35 Plus EU
1. Remove old seals.
2. Install the cord packing (8) by putting the two ends together and pressing them into the housing. Press the gasket back onto the areas
identied at '9 o'clock' (A), '12 o'clock' (B) and '3 o'clock' (C) with respect to the ends and then lay the rest of the gasket inside the hous-
ing.
3. Install the gasket (9) by aligning it as shown in Fig. 78 and pressing it into the housing.
9
8
A
C
B
78