Indutherm CC3000 - 4 Description of the System; Components of the System

System
description
TechDoku_CC1000_VCC1000_CC3000_VCC3000_GenPM_GB_86025010_86025110.doc
4–1
4 Description of the system
4.1 Components of the system
The system consists of several modules are assembled in one hous-
ing.
Inside the housing there are:
 mains cable and mains filter,
 microprocessor controlled induction generator PM-type,
 middle-frequency transformer,
 oscillating circuit capacities,
 pneumatic (magnet-) valves,
 pressure regulator for pressure of the sealing rod cylinder and
 pressure regulator for protective gas.
The front plate contains:
 front panel for control of the casting process and
 printer for output of a casting report.
To the melting system belongs:
 inductor housing, water cooled with inductor, crucible, insulations,
sealing rod unit, thermocouple,
 bell hinged, water-cooled and
 die and die cooler,
 drawing device,
 cutting device (option),
 bending unit (option) and
 granulating tank (option).