Indutherm CC3000 - System Parameter

Operation
TechDoku_CC1000_VCC1000_CC3000_VCC3000_GenPM_GB_860
25010_86025110.doc
7-12
7.3.4 System parameter
If you start from the main page and you press button ‘Info’ or <> for five seconds
you get access to the system parameter level.
Figure 33: System parameter
Note:
Please refer to the explanations for
the parameters in the attachment
software documentation. The ad-
justed values should be changed
with care and usually after consulta-
tion with the Indutherm service staff.
Display-functions:
000:
00002
Selected parameter: 000
Value of parameter is 2, which means here thermocouple
type N is activated
V
With pressing ‘arrow down’ you get to previous parameter
(here not possible).
Λ
With pressing ‘arrow up’ you get to next parameter 001.
-
With pressing ‘-’ you decrease the value to 1.
+
With pressing ‘+’ you increase the value to 3.
Service
With pressing the button near to this word you see infor-
mation of ‘Service Info Page 1’ with several serial numbers.
System Parameter
000: 00002
Temp. Sensor 0 Type
Haupt-
Λ
V
–
+
Service
Ser
Service
Λ
V
–
+