Ingenico FLEX IPP320 User Manual

FLEX iPP320 - Installation Guide_v1.50.docx
10
o Check the communication mode to the Point-of-sale System
• On the idle screen, if «MENU» is not displayed above the F1 key, press the
yellow key followed by the “0” key to unlock the terminal menus.
• Press F1, the terminal displays (Main menu) screen.
• Select (Configuration) then press the green key, the terminal displays
(Configuration) screen.
• Using F2 or F3 to navigate, select (Config. report) and press the green key.
• Select (POS Comm.) then press the green key.
• The terminal displays the current settings for communication to the Point-of-
sale System (scrolling with F2 key might be necessary in order to see the
pertinent information; see Appendix A for details).
2. Initializing the PIN pad
Initializing the PIN pad associates it with its configuration at the Desjardins host. Transactions
cannot be performed by the PIN pad until it has been initialized. Initialization involves three
steps: keys initialization, terminal initialization and public keys initialization.
IMPORTANT: The terminal must be activated at the Desjardins host before you can proceed
with initialization. To have the terminal activated:
 Call 514-281-2880 (toll-free 1-800-363-3514), select 9 for English, than option 1 and
option 4.
Once the terminal has been activated at the Desjardins host:
o On the idle screen, if «MENU» is not displayed above the F1 key, press the yellow key
followed by the “0” key to unlock the terminal menus.
o Press F1, the terminal displays (Main menu) screen.
o Select (Configuration) then press the green key, the terminal enters (Configuration)
screen.
o Using F2 or F3 to navigate, select (Initialize) and press the green key.
o Select (Initialize POS) then press the green key.
o The terminal displays (Please wait). The three required initialization types will launch
automatically:
• Keys initialization
• Terminal initialization
• Public keys initialisation
o During the entire initialization process the terminal displays (Please wait).

Ingenico FLEX IPP320 Specifications

General

Connectivity	Ethernet
Card Reader	Magnetic Stripe
Protocols	IP
Payment Methods	Contactless
Power Supply	Via Ethernet or external power adapter
Operating Temperature	0°C to +40°C