Ingenico FLEX IPP320 User Manual

FLEX iPP320 - Installation Guide_v1.50.docx
22
• On the idle screen, if «MENU» is not displayed above the F1 key, press the
yellow key followed by the “0” key to unlock the terminal menus.
• Press F1, the terminal displays (Main menu) screen.
• Select (Configuration) then press the green key, the terminal displays
(Configuration) screen.
• Using F2 or F3 to navigate, select (Term config) and press the green key.
• Select (POS comm) then press the green key.
• Select (Registration) and press the green key.
• The terminal displays (Waiting for POS communication).
• From the Point-of-sale System that you wish to associate with the Payment
Terminal, initiate a service request while the terminal is displaying (Waiting
for POS communication).
• Upon receipt of the request, the terminal will display the IP address of the
Point-of-sale System that sent the request, along with the message (Accept?).
• Press F4 to accept the association or F1 to clear the current association and
press the green key to put the terminal back in waiting mode.
3. Terminal number configuration
IMPORTANT: The terminal number will be given to you by Desjardins Installation Support.
To obtain the terminal number(s) associated with this merchant:
 Call (514) 281-7148 (or toll-free 1-866-333-1210)
o On the idle screen, if «MENU» is not displayed above the F1 key, press the yellow key
followed by the “0” key to unlock the terminal menus.
o Press F1, the terminal displays (Main menu) screen.
o Select (Configuration) then press the green key, the terminal displays (Configuration)
screen.
o Using F2 or F3 to navigate, select (Technician) and press the green key, the terminal
displays (Password) screen.
o Enter the password CDTC and press the green key, the terminal displays (Technician)
screen.
• To enter a letter, press the corresponding number then the F key until the desired
letter is displayed.
o Select (Terminal ID) then press the green key.
o The terminal displays the terminal number that is currently in memory.
o Press the yellow key to clear the number from memory and enter the terminal number in
MMMMMMSS format, where:
• MMMMMM = merchant number

Ingenico FLEX IPP320 Specifications

General

Connectivity	Ethernet
Card Reader	Magnetic Stripe
Protocols	IP
Payment Methods	Contactless
Power Supply	Via Ethernet or external power adapter
Operating Temperature	0°C to +40°C