Ingenico FLEX IPP320 - 2. Configuration of communication mode to Point-of-sale System; Configuration of serial communication mode; Configuration of IP communication mode

FLEX iPP320 - Installation Guide_v1.50.docx
21
• The terminal conducts a test of its IP connectivity and displays the result on
the screen (see Appendix C for details).
2. Configuration of communication mode to Point-of-sale System
o Configuration of serial communication mode
• On the idle screen, if «MENU» is not displayed above the F1 key, press the
yellow key followed by the “0” key to unlock the terminal menus.
• Press F1, the terminal displays (Main menu) screen.
• Select (Configuration) then press the green key, the terminal displays
(Configuration) screen.
• Using F2 or F3 to navigate, select (Term config) and press the green key.
• Select (POS comm) then press the green key.
• Select (Configuration) then press the green key.
• Select (RS232) then press the green key.
• Select required baud rate (9600 Bps recommended) then press the green key.
• The terminal displays (RS232 activated).
o Configuration of IP communication mode
• On the idle screen, if «MENU» is not displayed above the F1 key, press the
yellow key followed by the “0” key to unlock the terminal menus.
• Press F1, the terminal displays (Main menu) screen.
• Select (Configuration) then press the green key, the terminal displays
(Configuration) screen.
• Using F2 or F3 to navigate, select (Term config) and press the green key.
• Select (POS comm) then press the green key.
• Select (Configuration) then press the green key.
• Select (IP) then press the green key.
• The terminal displays (IP activated).
Next, the IP address of the Point-of-sale System from which transactions will be
sent must be registered on the FLEX terminal