Ingenico FLEX IPP320 - Page 20

FLEX iPP320 - Installation Guide_v1.50.docx
20
4. On the (Gateway) screen, enter the terminal IP gateway and press the
green key.
5. On the (DNS server 1) screen, enter the primary DNS server IP
address and press the green key.
6. On the (DNS server 2) screen, enter the secondary DNS server IP
address and press the green key.
7. The terminal then reboots to activate the settings.
• As needed, press the red key to return to the idle screen.
• On the idle screen, if «MENU» is not displayed above the F1 key, press the
yellow key followed by the “0” key to unlock the terminal menus.
• Press F1, the terminal displays (Main menu) screen.
• Select (Configuration) then press the green key, the terminal displays
(Configuration) screen.
• Using F2 or F3 to navigate, select (Initialize) and press the green key.
• Select (RMI host) then press the green key.
• Select (IP) then press the green key.
• The terminal displays the IP address of the Desjardins host that it has in
memory.
• If the address differs from 142.195.251.53,
 Press the yellow key to clear the IP address from memory and enter the
IP address of the Desjardins host (142.195.251.53).
• Press the green key to confirm the entry.
• Press the red key until the terminal returns to the (Initialize) screen.
• Select (Download host) then press the green key.
• Select (IP) then press the green key.
• The terminal displays the IP address of the Desjardins download centre that it
has in memory.
• If the address differs from 142.195.251.54,
 Press the yellow key to clear the IP address from memory and enter the
IP address of the Desjardins download centre (142.195.251.54).
• Press the green key to confirm the entry.
It is then recommended to validate communication with the host using the IP Status:
• On the idle screen, if «MENU» is not displayed above the F1 key, press the
yellow key followed by the “0” key to unlock the terminal menus.
• Press F1, the terminal displays (Main menu) screen.
• Select (Configuration) then press the green key, the terminal displays
(Configuration) screen.
• Using F2 or F3 to navigate, select (Diagnostic) and press the green key.
• Select (IP Status) then press the green key.
• Select (DESJARDINS) then press the green key.
• Select (Status) then press the green key.