innovaphone IP DECT Page 77
The entry fields for a SIP registration are:
Direct Dial Using
Direct Dial
, a call setup to the specified call num-
ber is initiated as soon as the handset is picked up. A
conceivable scenario would be a lift emergency tele-
phone that is connected with the security control room,
for example.
Locked White
List
Here, you can specify a comma-separated list of call
numbers that may also be dialled in the case of a locked
telephone (for example, emergency services numbers,
like 110, 911).
Server Address
(primary)
The IP address or the proxy server address of the SIP
provider (for example sipgate.de, 217.10.79.9), to
where the SIP messages (for example, register) are to be
sent.
Server Address
(secondary)
If the SIP provider has an alternative IP address or proxy
server, then it can be entered here. In the event of failure
of the primary server (for example, when maintenance is
being carried out), the registration is then retained.
STUN Server The STUN server name or IP address must be configured
if the telephone uses a private IP address, but the SIP
server is accessible under a public IP address. The value
is given by the SIP provider or administrator (for
example, stun.xten.com or 64.69.76.23). You can
choose any STUN server; it does not necessarily have to
correspond to the one of the SIP provider.
ID @ Here, you enter the user ID followed by the SIP provider
domain name (for example, 8111111e0@sipgate.de).
Display Name The name you enter here, which corresponds to the part
in front of the @ of the URI, is required for the registra-
tion if the number (Account) was not specified (for
example, 8111111e0).
Account Likewise in this protocol, a call number is required for the
registration, which corresponds to the part in front of the
@ of the URI (for example, 8111111e0).
Password /
Retype
The password (Password) of the SIP Account must be
specified and confirmed (Retype).
To Next Page
Loading...
