Inovance MD300 - Chapter 5 Function Parameter Table

Function Parameter Table MD320/MD320N User Manual
68
Chapter 5 Function Parameter Table
If FP-00 is set to non-zero value, it means parameter protection password is set, and the
parameter menu cannot be entered until correct password is input. To cancel the password, it
needs to set FP-00 to “0”.
The parameters in the shortcut menu are free from password protection.
The symbols in the function table are described as follows:
“
☆
”
：
It indicates that the parameter setup value can be modied when the inverter is in stop
status and running status.
“
★
”
：
It indicates that the parameter setup value cannot be modied when the inverter is in the
running status.
“●”
：
It indicates that the numerical value of the parameter is the actually measured value,
which cannot be modied.
“*”: It indicates this parameter is “Factory default parameter” and can be set only by the
manufacturer.