Integra MEDIAJET - Page 31

MEDIAJET – Operating instructions V09 Operation
31
www.integra-biosciences.com
Dish height (mm) Stacking height of the Petri
dishes used (see below). To
use dishes with a height of
more than 21 mm, underlay
the filling nozzle holder with the
supplied base plate (see “3.4.5
Base plate for filling nozzle
holder” on page 21).
12-25 mm 16 mm
Rotor movement Sets of the speed of the rotor.
“Slow” is particularly well
suited for preventing
overflowing of the dishes with a
high filling volume.
“Spread” is used in order to
achieve homogenous
distribution of the agar with low
filling volumes.
Slow
Normal
Spread
Normal
Continuous
filling
Allows to switch the
continuous filling on or off.
“ON” continuously fills the
number of dishes specified in
the program. The process
does not stop when all dishes
in the carousel are filled.
“OFF” pauses the process
after all dishes in the carousel
are filled.
(For further information see
“4.4.2
Filling dishes
continuously or
discontinuously” on page 32.)
ON
OFF
OFF
Shaker level
(Pour plate)
Sets the shaking speed of the
rotor for pour plate applications
(has to be enabled in program
configuration, see “4.2
Adapt
system parameter” on
page 26).
1-5
OFF
OFF
Batch mode Allows highly planar agar
surfaces by filling a defined
number of dishes (i. e. a batch)
per carousel stack, see “4.4.3
Filling dishes in Batch mode”
on page 33 (has to be enabled
in program configuration, see
“4.2
Adapt system parameter”
on page 26).
1-20
dishes/
batch
OFF
OFF
Program
parameter
Description Value
range
Basic
setting