Intercomp LP600 - Page 22

LP600 Users Manual
Rev E, February 2017
Page 22 of 43
7. The display will show “.”. Press the PRINT/ACCUMULATE button. The
flashing digit shows the current setting. The number displayed is the minutes that
the scale can remain idle before it automatically shuts down. Setting this number to
“” will disable the function, meaning the scale will never shut itself off. Use the
LOCAL/TOTAL button the advance the number and the ZERO button to move the
number flashing to the left. When the display shows the desired number, press the
PRINT/ACCUMULATE button.
8. The display will show “”. Press the PRINT/ACCUMULATE button. The
flashing digit shows the current setting. The number enables the scales different
print modes. (0 for on-demand, 1 for continuous, 2 for accumulating total axle
format, and 3 for accumulating total standard format) Use the LOCAL/TOTAL
button to increment and the ZERO button to decrement the number. When the
display shows the desired number, press the PRINT/ACCUMULATE button.
9. The display will show “”. Press the PRINT/ACCUMULATE button. The
flashing display shows the current setting of the printer baud rate. The baud rates
available are: 1200, 2400, 4800, 9600, 19200, 38400, 57600, and 115200. Use the
LOCAL/TOTAL button or the ZERO button to toggle through the available rates.
When the display shows the desired number, press the PRINT/ACCUMULATE
button.
10.The display will show “”. Press the PRINT/ACCUMULATE button. The lb or
the kg icon will flash in the upper left of the display. This will set the scale to
measure pounds (lb) or kilograms (kg). Use the LOCAL/TOTAL button or the
ZERO button to toggle between the settings. When the desired icon is flashing,
press the PRINT/ACCUMULATE button.
11.The display will show “”. Press the PRINT/ACCUMULATE button. The
flashing display shows the current setting. There are 4 protocol settings for the
scale, Standard (“”), Low Power (“”), Current Loop (“.”), or “”.
Standard is the legacy setting for use in wireless and wired scale networks. Low
Power will significantly improve the wireless battery life for all non-‘host’ scales.
(maximum number of scales in this mode is 32) Current Loop is not used in the
LP600. When scales are not part of a totalizing network, battery life will be
improved if “” is chosen. Use the LOCAL/TOTAL button or the ZERO button to
cycle through the settings. When the desired protocol is flashing, press the PRINT/
ACCUMULATE button.
12.The display will show “.”. Press the PRINT/ACCUMULATE button. The
display will show the current setting flashing. This is the setting of the interface
baud rate. There are two settings available, 9600 and 115200. Use the
LOCAL/TOTAL button or the ZERO button to toggle between the settings. When
the desired baud rate is flashing, press the PRINT/ ACCUMULATE button.