17 Programming — Controller Setup
To identify the pool/spa control system’s components:
1. Locate the “MultiWave Pool & Spa Control System Worksheet for Programming” at the back
of the accompanying Installation Guide.
MultiWave Pool & Spa Control System
Worksheet for Programming
SYSTEM COMPONENTS:
Freeze (Air Temperature) Sensor
Water Temperature Sensor
Solar (Air Temperature) Sensor
Antenna Extender
Pentair Variable Speed Pump (VSP)
AutoPilot Salt Chlorine Generator (SCG)
FREEZE OPTION IS DESIRED.
OTHER Z-WAVE DEVICES ARE USED.
P5043ME Expansion Module
Water Feature (Act 3)
Heater #1
Heater #2
Solar Temperature System (Act 4)
Remote Switch
Other Variable Speed Pump (VSP)
Act 2
Act 1
Act 3
Act 4
Power In
240 VAC
Heater #1
Heater #2
Remote
Switch
123 4 5 6 7 8 9
1 2 3 4 5
Water
Temperature
Sensor
Circuit
1
Circuit
2
Circuit
3
Circuit
4
Circuit
5
Power In
120or240 VAC
L1 120
VACWire
L2
120V
240V
Solar/Air
Temperature
Sensor
Freeze/Air
Temperature
Sensor
Antenna
Extender
(CAT5)
Pentair VSP and/or SCG
OR Expansion Modul
e
NOTE: For circuit options, see Chapters 4 through 6.
Put a dash in the circuits that are not used.
Circuit 1 _______________________________________
Circuit 2 _______________________________________
Circuit 3 _______________________________________
Circuit 4 _______________________________________
Circuit 5 _______________________________________
NOTE: If this system does not include P5043ME,
draw an “X” through the entire second column.
PE653 Receive 5043ME Expansion Module
Other VSP
(CAT5)
Figure 2-4. MultiWave Pool & Spa Control System Worksheet for Programming.
2. Use this worksheet, lled out by the installer, to identify the system’s installed components,
which components are assigned to the circuits, whether the freeze option is desired and
whether the controller will be used with other Z-Wave devices.
3. Read through Chapter 2 through Chapter 7 and Chapter 10 through Chapter 12 and check
off the sections listed at the beginning of each chapter that you want to include in your
programming session. NOTE: All sessions should begin with all of this chapter (Chapter 2).
Planning a Programming Session
• In Chapter 3, read through the procedures listed, and decide which of them apply to the
components included in your system: 1- or 2-speed pump, sensors, booster pump, spa
pump, and/or heaters.
• Include Chapter 4 if your system includes a P5043ME expansion module, and choose
procedures according to the components listed under it on the worksheet.
• Include Chapter 5 if the freeze option is checked on the worksheet.
• If the system includes a variable speed pump, determine which procedures in Chapter 6 to
follow, based on if it is Pentair or another brand.
• Include all of Chapter 7 if the system includes an AutoPilot Salt Chlorine Generator.
• Chapter 10 procedures need to be included if your system will coordinate with other Z-Wave
devices.
• Look through Chapter 11 and Chapter 12 for procedures involving special features, like a
PE650 Receiver, secondary controller or third-party network.
To Next Page
Loading...
