Intermatic MULTIWAVE PE653RC - Programming Overview

www.intermatic.com
16
MultiWave Control System Programming and User Guide
Programming Overview
1
2
3
4
5
ENTER
P/S
Display
Labels
ON/OFF
Function
Buttons
Figure 2-2. Components of hand-held controller.
P/S Button
(Pool/Spa)
Selection
Arrow
Buttons
Current
Network Being
Controlled
Target temp
settings for pool
(P) or spa (S)
(if sensors are
installed)
“Air”, “Solar” and “Pool”
tells current temps
(if sensors are installed)
Figure 2-3. Controller main display screen.
“OK” indicates
controller is
communicating
with the receiver
Current
Time
Circuits are
ON
Read through this section to familiarize yourself with the controller’s navigation and the pool/
spa control system’s components. Then plan your programming session, using the procedures in
Chapter 2 through Chapter 7 and Chapter 10 through Chapter 12 that apply to your installation.
To navigate through the screens of the controller:
1. Press and release any button to activate the controller.
2. Press ENTER repeatedly to walk through the main pages available. Each main page will be
identied at the top with the component/components it represents.
3. Press P/S and ENTER simultaneously from any main page to access its LEARN MODE.