19 Programming — Controller Setup
Linking the Controller to Receiver
Follow this procedure to create a network connection between the controller and receiver.
1. If necessary, press P/S and ENTER simultaneously to access LEARN MODE.
2. Press 3 INCLUDE DEVICE.
3. With a blunt object, press the INCLUDE button on the receiver. See Figure 2-5. The
controller displays SUCCESSFUL, and then returns to the LEARN MODE screen.
NOTE: If FAILURE appears at the bottom of the screen, repeat the procedures Resetting the
Controller and Resetting the Receiver. If the problem persists, contact Intermatic.
Testing Z-Wave
®
Reception
The MultiWave Control System is compatible with Z-Wave-enabled networks. The controller
communicates with the receiver by transmitting an RF signal. You need to make sure that the
receiver is receiving the signal from the controller in every area of the pool/spa system.
1. While standing in a position near the receiver, press a button on the controller to activate the
screen.
2. Press 1 on the controller and check the receiver to verify that circuit 1 changes states.
3. Move further from the receiver and repeat the test in step 2.
NOTE: If at any point OUT OF RANGE appears on the controller, follow the instructions under
“Remoting the Antenna” to improve reception.
4. Move around the receiver, working into all areas of the pool/spa system and repeating the
test.
To Next Page
Loading...
