Intermec CK30

Chapter 3 — Developing and Installing Applications
90 CK30 Handheld Computer User’s Manual
Script Command Description
EXEC Launches a specified program and waits (up
to 10 minutes) for it to complete.
CALL Processes a specified file of commands and
returns. When you use the CALL
command, the execution of the current file
pauses while a new file that follows the
same set of commands executes. Once the
new file completes executing, AutoRun.exe
continues processing the current file.
CHAIN Processes a specified file of commands and
does not return. This command allows you
to call another file that follows the same set
of commands and stop processing the
current file.
RUN Loads a specified program and executes it.
Specifies the show window attribute so the
user interface is visible when the
application launches.
LOAD Loads a specified program and executes it.
Specifies the hide window attribute so the
user interface is hidden initially.
4 Save this Notepad file as AutoRun.dat.
5 Copy the AutoRun.dat file to the \2577 folder on your
CK30.
During every boot, the system scans for AutoRun.dat in the
\2577 folder on first the SDMMC Disk and then the CK_FFS
folder. The CK30 executes the first AutoRun.dat file that it
finds.
Here is a sample AutoRun.dat file that runs a dialer application,
connects to a VPN, and establishes a TE 2000 session:
EXEC “\Program Files\My Dialer\Dialer.exe” 348-2600
EXEC “\Program Files\My VPN\Connect.exe” MyDomain
RUN “\Program Files\TE2000\TE2000.exe” MyServer