Intermec CK30

Chapter 2 — Configuring the CK30
CK30 Handheld Computer User’s Manual 51
The Intermec Application Server translate UDP Plus packets on
the wireless network into TCP/IP packets on the wired network
and vice versa. The access point acts as a bridge to allow
communications between the wired network and the wireless
network.
To use wireless communications in a UDP Plus network
1 Configure these network parameters on each CK30 in the
network:
• Network Name (SSID)
• Controller IP Address
• IP Settings (if not using DHCP)
• Network Port
2 Configure the security. For help, see “Configuring Security”
on page 55.
You can configure the network parameters on the CK30 with
the Configuration Utility. For help, see “Configuring the CK30
With the Configuration Utility” on page 36.
Configuring Ethernet Communications on Older CK30s
Note: The Ethernet option is no longer available on the CK30.
The information in this section is useful only if you already have
an installed base of older CK30s with the Ethernet option.
You can use an older CK30 directly in an Ethernet network if
you ordered the Ethernet option on your CK30A. Insert the
CK30A into an AD1 or AD2 Communications Dock. The
communications dock has an Ethernet connector that makes it
possible for the CK30 to communicate with your Ethernet
network.